Eskimo S33Q8 User Manual download pdf (Page 10)

Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST

Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST10

Operator's Manual

43cc Mako™ Power Ice Auger

SERVICE, TROUBLESHOOTING

AND REPAIR

SERVICE INFORMATION

At Ardisam, we build quality and durability into the design of

our products; but no amount of careful design by us, and care-

ful maintenance by you, can guarantee a repair-free life for your

auger. Most repairs will be minor, and easily xed by following

the suggestions in the troubleshooting guide in this section.

The guide will help you pinpoint the causes of common problems

and identify remedies.

For more complicated repairs, you may want to rely on your

retailer or an authorized repair center (contact your retailer for

a list of authorized mechanics in your area). A parts breakdown

is included in this manual and can also be found on our website,

www.geteskimo.com.

We will always be glad to answer any questions you have, or

help you nd suitable assistance. To order parts or inquire about

warranty, call or write us at the address found below, under the

section ordering repair parts.

ICE POINT REPLACEMENT SEE FIGURE 1

1. Remove blade protector and both blades.

2. Remove nut and retaining bolt from point.

3. Using a locking pliers, grasp point and pull out. If holder

doesn’t come out with the point, remove with pliers.

4. With locking pliers, push in new point and holder aligning

bolt hole in point with holes in auger shaft. DO NOT damage

end of point.

NOTE: When installing holder in auger shaft, edges of holder

may shave o.

5. Insert retaining bolt and tighten with nut.

6. Re-attach both blades and put blade protector back on.

CAUTION

AVOID INJURY! AUGER BLADES AND POINT ARE

EXTREMELY SHARP. USE CAUTION WHEN REMOVING

& REPLACING.

PRACTICE SAFETY AT ALL TIMES. ENGINE MUST BE

TURNED OFF AND ALLOWED TO COOL, AND SPARK

PLUG WIRE MUST BE DISCONNECTED BEFORE

ATTEMPTING ANY MAINTENANCE OR REPAIR.

Figure 1

auger shaft

nut

point

holder

bolt

bolt hole

ORDERING REPAIR PARTS

Parts may be obtained from the store where your auger was

purchased or direct from the factory. To order from the factory,

call, e-mail, or order online at www.geteskimo.com:

Eskimo® Ice Fishing Gear,

A Division of Ardisam, Inc.

1-800-345-6007

E-mail: [email protected]om

Please include the following information with your order:

1. Part numbers

2. Part description

3. Quantity

4. Model number and serial number

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Eskimo S33Q8 User Manual Page 10

Comments to this Manuals

Related products and manuals for Sports and recreation Eskimo S33Q8