7
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
Operator’s Manual
ESKIMO
®
QuickFlip
™
2
20. Secure the edge trim in place using the (15) #6 x 3/8” sheet
metal screws provided. A cordless drill and Phillips head bit is
recommended for this step, but is not necessary. SEE FIGURE
10
Note: Screws should be spaced evenly apart. This step does
mean you will put very small holes in your shelter skin to
keep the edge trim and skin securely attached to the sled lip.
This will in no way affect the performance of your shelter.
ADDITIONAL INSTALLATION
21. Locate the included 8 foot tow rope that was in the hardware
bag. To install the tow rope locate the two holes in the front
of the sled and push each end of the rope through a hole. Tie
a knot at each end of the rope to keep the rope from pulling
through the holes. This tow rope is designed for manual pull-
ing by hand only. DO NOT tow behind a motorized vehicle
with rope. For high-speed towing, you should purchase the
Eskimo Universal Tow Hitch accessory (11608).
SETUP AND TAKEDOWN INSTRUCTIONS
Set-Up: From the outside or inside of the shelter depending
on your preference, start with the lower frame support and
fully extend until it snaps into place. As you extend each frame
support to the “in use” position make sure they snap into place.
Lastly secure all frame supports by attaching the appropriate
spreader poles as directed earlier in this manual.
Note: By detaching the back spreader pole and the front side
spreaders, you can flip the shelter back halfway into a “wind-
break” position on nice days.
Take-Down: Close all window covers, vents covers and zip door
shut. Remove all spreader poles and place in the bottom of the
sled. Starting with the rear frame support collapse each frame
support working toward the front of the shelter and lower frame
support. Flip all frame poles back. Use caution when flipping
poles back to make sure no parts of the skin get pinched or torn.
Fold excess skin inside of sled when complete.
Note: Use extreme caution so you don’t rip or tear any portion
of the skin, especially around the hinges or any pinch point
areas.
Note: An Eskimo Travel Cover (69171) may be purchased to
protect your shelter while transporting to and from the lake.
LONG-TERM STORAGE
• Alwaysmakesureyouriceshelteriscompletelydrybefore
storing for long periods of time. Storing your ice shelter
when damp or wet may cause mold and mildew damage.
• Removeskinfromicesheltersledandpoles.
• Cleanallsalt,moisture and debris from your shelter skin,
sled and poes. Wipe down poles with a wet rag.
Note: Lubricate the slide poles with a silicon spray at
least seasonally. Do not use oil or grease as a lubricant.
Note: Before attaching skin for use, spray silicon spray
inside of poles for ease of sliding.
• Store skin, poles an sled in a cool, dry place away from
rodents.
cross brace
pole
(12 pages)
(48 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals